Finally, prepare the i.MX6 Quad board for U-Boot:
- Connect to your i.MX6 Quad board with a serial connection at a baud rate of 115200.
- Set the following environment variables in the U-Boot terminal:
setenv bootcmd_demo_dt 'mmc dev 1; fatload mmc 1:1 20000000 demo.image; fatload mmc 1:1 4FFE0000 imx6q-sabrelite.dtb; bootm 20000000 - 4FFE0000' setenv bootcmd 'run bootcmd_demo_dt' saveenv
Note: The file demo.image was built with the mkimage tool in Building U-Boot Image.
- Reset the i.MX6 Quad board.
Now your i.MX6 Quad board is ready to run your application.
© 2018 The Qt Company Ltd. Documentation contributions included herein are the copyrights of their respective owners. The documentation provided herein is licensed under the terms of the GNU Free Documentation License version 1.3 as published by the Free Software Foundation. Qt and respective logos are trademarks of The Qt Company Ltd. in Finland and/or other countries worldwide. All other trademarks are property of their respective owners.