# PathCubic QML Type

Defines a cubic Bezier curve with two control points More...

 Import Statement: import QtQuick 2.5

## Detailed Description

The following QML produces the path shown below:

 ```Path { startX: 20; startY: 0 PathCubic { x: 180; y: 0 control1X: -10; control1Y: 90 control2X: 210; control2Y: 90 } }```

## Property Documentation

 control1X : real

Defines the position of the first control point.

 control1Y : real

Defines the position of the first control point.

 control2X : real

Defines the position of the second control point.

 control2Y : real

Defines the position of the second control point.

 relativeControl1X : real

Defines the positions of the control points relative to the curve's start.

If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.

Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.

 relativeControl1Y : real

Defines the positions of the control points relative to the curve's start.

If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.

Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.

 relativeControl2X : real

Defines the positions of the control points relative to the curve's start.

If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.

Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.

 relativeControl2Y : real

Defines the positions of the control points relative to the curve's start.

If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.

Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.

 relativeX : real

Defines the end point of the curve relative to its start.

If both a relative and absolute end position are specified for a single axis, the relative position will be used.

Relative and absolute positions can be mixed, for example it is valid to set a relative x and an absolute y.

 relativeY : real

Defines the end point of the curve relative to its start.

If both a relative and absolute end position are specified for a single axis, the relative position will be used.

Relative and absolute positions can be mixed, for example it is valid to set a relative x and an absolute y.

 x : real

Defines the end point of the curve.