Using TinyCAN Backend

The TinyCAN backend encapsulates the low-level API to work with the MHS Elektronik CAN adapters.

Creating CAN Bus Devices

At first it is necessary to check that QCanBus provides the desired backend:

foreach (const QByteArray &backend, QCanBus::instance()->plugins()) {
    if (backend == "tinycan") {
        // were found

Where tinycan is the backend name.

Next, a connection to a specific interface can be established:

QCanBusDevice *device = QCanBus::instance()->createDevice("tinycan", QStringLiteral("channela"));

Where channela is the active CAN interface name. The TinyCAN backend provides two interfaces, channela and channelb.

Note: Only the USB adapters are currently supported by this backend.

The device is now open for writing and reading CAN frames:

QCanBusFrame frame;
QByteArray payload("A36E");

The reading can be done using the readFrame() method. The framesReceived() signal is emitted when new frames are available for reading:

QCanBusFrame frame = device->readFrame();

TinyCAN supports the following configurations that can be controlled through setConfigurationParameter():

Configuration parameter keyDescription
QCanBusDevice::BitRateKeyDetermines the bit rate of the CAN bus connection. The following bit rates are supported: 10000, 20000, 50000, 100000, 125000, 250000, 500000, 800000, 1000000.

© 2016 The Qt Company Ltd. Documentation contributions included herein are the copyrights of their respective owners. The documentation provided herein is licensed under the terms of the GNU Free Documentation License version 1.3 as published by the Free Software Foundation. Qt and respective logos are trademarks of The Qt Company Ltd. in Finland and/or other countries worldwide. All other trademarks are property of their respective owners.