QNearFieldManager class provides access to notifications for NFC events. More…
NFC Forum devices support two modes of communications. The first mode, peer-to-peer communications, is used to communicate between two NFC Forum devices. The second mode, master/slave communications, is used to communicate between an NFC Forum device and an NFC Forum Tag or Contactless Card. The
targetDetected() signal is emitted when a target device enters communications range. Communications can be initiated from the slot connected to this signal.
NFC Forum devices generally operate as the master in master/slave communications. Some devices are also capable of operating as the slave, so called Card Emulation mode. In this mode the local NFC device emulates a NFC Forum Tag or Contactless Card.
Applications can connect to the
targetLost() signals to get notified when an NFC Forum Tag enters or leaves proximity. Before these signals are emitted target detection must be started with the
startTargetDetection() function. Target detection can be stopped with the
stopTargetDetection() function. When the target is no longer required the target should be deleted as other applications may be blocked from accessing the target.
- class PySide6.QtNfc.QNearFieldManager([parent=None])#
Constructs a new near field manager with
This enum describes the different states a NFC adapter can have.
The nfc adapter is offline.
The nfc adapter is turning on.
The nfc adapter is online.
The nfc adapter is turning off.
- Return type
true if the device has a NFC adapter and it is turned on; otherwise returns
- Return type
true if the underlying device has a NFC adapter; otherwise returns
false. If an
accessMethod is given, the function returns
true only if the NFC adapter supports the given
message – str
Sets the message shown to the user by the system. If the target detection is running the
message will be updated immediately and can be used as a progress message. The last message set before a call to
startTargetDetection() without an error message is used as a success message. If the target detection is not running the
message will be used as the initial message when the next detection is started. By default no message is shown to the user.
Currently, this function only has an effect on iOS because a popup is shown by the system during the scan. On iOS, this
message is mapped to the alert message which is shown upon successful completion of the scan. Other platforms will ignore
- Return type
Starts detecting targets and returns
true if target detection is successfully started; otherwise returns
false. Causes the
targetDetected() signal to be emitted when a target is within proximity. Only tags with the given
accessMethod will be delivered. Active detection continues until
stopTargetDetection() has been called.
To detect targets with a different
stopTargetDetection() must be called first.
errorMessage – str
Stops detecting targets. The
targetDetected() signal will no longer be emitted until another call to
startTargetDetection() is made. Targets detected before are still valid.
errorMessage is provided, this is a hint to the system that the goal, the application had, was not reached. The
errorMessage and a matching error icon are shown to the user. Calling this function with an empty
errorMessage, implies a successful operation end; otherwise an
errorMessage should be passed to this function.
errorMessage only has an effect on iOS because a popup is shown by the system during the scan where the
errorMessage is visible. Other platforms will ignore this parameter.