Document Structure

The document structuring commands are for dividing your document into sections. QDoc supports four levels of section: \section1, \section2, \section3, and \section4. The section commands correspond to the traditional section, subsection, etc used in outlining.

Section commands

In general a document structuring command considers everything that follows it until the first line break as its argument. The argument is rendered as the unit's title. If the title needs to be spanned over several lines, make sure that each line (except the last one) is ended with a backslash.

In total, there are four levels for sections in QDoc: \section1, \section2, \section3 and \section4. These correspond to the traditional section, subsection, subsubsection and subsubsubsection.

There is a strict ordering of the section units:

section1
      |
      section2
             |
             section3
                    |
                    section4

When sections are used, the first section command should be section1.

/*!
    \section1 Basic Qt

    This is the first section.


        \section2 Getting Started

        This is the first subsection.


            \section3 Hello Qt

            This is the first subsubsection.


            \section3 Making Connections

            This is the second subsubsection.


            \section3 Using the Reference Documentation

            This is the third subsubsection.


        \section2 Creating Dialogs

        This is the second subsection.


            \section3 Subclassing QDialog

            This is the first subsubsection.

            ...


    \section1 Intermediate Qt

    This is the second section.


        \section2 Layout Management

        This is the second section's first subsection.


            \section3 Basic Layouts

            This is the first subsubsection.

        ...
*/

Each section is a logical unit in the document. The section heading appears in the automatically generated table of contents that normally appears in the upper right-hand corner of the page.

\section1

The \section1 command starts a new section.

See Section commands for an explanation of the various section units, command argument, and rendering.

\section2

The \section2 command starts a new section.

See Section commands for an explanation of the various section units, command argument, and rendering.

\section3

The \section3 command starts a new section.

See Section commands for an explanation of the various section units, command argument, and rendering.

\section4

The \section4 command starts a new section.

See Section commands for an explanation of the various section units, command argument, and rendering.